![]() The port number to be used by the FOCAS2/Ethernet functions. After the settings are filled out, press the soft key to display the settings for FOCAS2 communication.įill out the settings on the FOCAS2/Ethernet settings page.(This is not required and can be left empty). The IP address of the router on the network. ![]() The mask the server will use on the network. Press the soft key to display the ethernet settings.įill out the settings on the Ethernet settings page.If ethernet is embedded, you can use the instead. Press the soft key to display the Ethernet Settings screen.If this soft key is missing please refer to the related NC Parameters at the end of this section. Press the continue soft key until the soft key appears.Ensure there is a physical network connection between the node running deviceWISE and the CNC.The steps below describes how to enable FOCAS on a FANUC CNC equipped Embedded Ethernet or an Ethernet Board. Setting up Ethernet Board and Embedded Ethernet function on the CNCįOCAS functions can remotely control and monitor the CNC using a PC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |